Description
- Material:Stainless steel;
- Voltage: 110V/220Volt;
- In Diameter 25mm;
- Length: 95mm;
- Wattage:500Watt;
- Cross section: 3x3mm/4.2×2.2mm/3.5×3.5mm;
- With thermocouple: Yes, K type;
- With Grounding wire: Yes;
- Lead Wire: 1Meter length;
- Temperature Range:0-500C;
- Package:1PC hot runner coil heater;
- Applications: The applications the coiled nozzle heaters suit are: hot sprue bushings, sealing bars, dies, hot metal forming punches and many more.
Pay attention:
01. Before installation, use a multimeter to test whether the heating coil is powered on. If there are no issues with the measurement, then install it.
02. The heating ring must be in close contact with the mold. The tighter the contact, the higher the thermal efficiency and the faster the heating rate.
03.When wiring, make sure to tighten it. After tightening, it is best to forcefully pull down the power cord by hand, otherwise poor contact may cause ignition and tripping
Reviews
There are no reviews yet.